![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#36
|
|||
|
|||
![]()
On Tuesday, June 17, 2014 6:46:14 PM UTC+12, Andrew wrote:
I was worried by writers in this thread who have mentioned aerotowing at sites where a straight ahead landing from a low PT3 could not be safely made. Single-engine power pilots often accept catastrophic risks (e.g. from engine failures) but we glider pilots don't have to. If the PT3 danger is only to the glider, I guess that's ok, if the owners and their insurance company have no objection. But if personal injury is risked by PT3, I hope everyone agrees that such sites should not be used for aerotowing gliders. I disagree. Options in the event of a tow failure include: 1) land ahead 2) land cross wind 3) do a (approx) 180 and land downwind 4) do a (approx) 180, enter an abbreviated downwind leg, land crosswind 5) do a (approx) 180, enter an abbreviated downwind leg, land upwind 6) do a (approx) 180, do a normal downwind leg, land upwind As long as at least *one* of those options is available at all times the site is fine. Which ones are appropriate does change according to conditions. For example 3) is likely to be a bad idea in all but the lightest winds. But as the wind strength picks up the opportunities for the others increases quickly. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parowan Fatal Crash | ContestID67[_2_] | Soaring | 30 | July 3rd 09 03:43 AM |
Rare fatal CH-801 crash | Jim Logajan | Home Built | 8 | June 22nd 09 03:24 AM |
Fatal crash in NW Washington | Rich S.[_1_] | Home Built | 1 | February 17th 08 02:38 AM |
Fatal Crash | Monty | General Aviation | 1 | December 12th 07 09:06 PM |
Fatal Crash in Fittstown, OK | GeorgeC | Piloting | 3 | March 7th 06 05:03 AM |