|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
August 10th 14, 04:05 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm Problems
Good one! But more seriously, all of these boards/products have been in the same installation. Are you sure that is solid?
For example the GPS active antenna might be at fault? Or too close to other GPS antennas or other equipment (they do suffer interference in those cases)? Or a bad cable? It seems highly unlikely that once they replaced the main board, there would still be the same fault in the board. You may need to debug your installation, at least until you can reasonably prove that it is not the problem. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| unusual PowerFlarm problems | Mitch Polinsky[_2_] | Soaring | 4 | June 25th 13 06:02 AM |
| PowerFLARM USB 3 cables and ConnectMe to PowerFLARM through V7 | Tim Taylor | Soaring | 20 | June 17th 13 05:56 PM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM | Paul Remde | Soaring | 9 | November 6th 10 04:30 AM |
| PowerFLARM | Greg Arnold[_2_] | Soaring | 6 | November 2nd 10 09:32 AM |
Threaded Mode