![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
![]()
On Tuesday, September 16, 2014 11:01:59 AM UTC-4, Sean Fidler wrote:
So, what am I missing? Have I set myself up for a ClearNav feature review :-)? Does the CN or perhaps the LX9000 handle MATs better? CN plots a blue ellipse on the map that becomes visible during the later stages of a MAT. What the ellipse means is this: if you fly to any turnpoint inside the ellipse, then to the finish, you will be early. The ellipse updates continuously and accounts for wind, altitude, predicted thermal climb rate. Evan Ludeman for CNi |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
36 Inch Hdtv | [email protected] | Piloting | 0 | May 17th 09 12:48 PM |
NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | Home Built | 4 | March 11th 04 11:31 PM |
NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | Aviation Marketplace | 4 | March 11th 04 11:31 PM |
NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | General Aviation | 4 | March 11th 04 11:31 PM |
3 1/8 inch compass | Steve Beaver | Home Built | 2 | October 21st 03 12:20 AM |