|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 1st 15, 03:24 AM
posted to rec.aviation.soaring
|
|||
|
|||
Cambridge GPS-NAV Navpoints File
I am trying to create a Restricted Area Navpoint with an "R" Attribute, ceiling altitude, and radius so my GPS-NAV can alert me if I invade that space.. The old MS-DOS software allowed creation of such a Navpoint but the subsequent Aero Explorer does not. The .dat file structure appears to be:
ID #,Latitude,Longitude,Elevation,Attributes,Name,Tex t Presumably ceiling altitude and radius would follow additional commas, but in what order or where in the line? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cambridge file conversions for OLC (yet again) | Steve Leonard[_2_] | Soaring | 9 | July 6th 14 03:29 PM |
| Trouble transferring file from Cambridge 302 | [email protected] | Soaring | 9 | May 13th 09 01:36 AM |
| Cambridge .dat waypoint file spec | David | Soaring | 1 | September 27th 04 05:19 AM |
| Cambridge 302/Cambridge 3UTIQ255 utility/ WinPilot/iPAQ 4155 | Nathan Whelchel | Soaring | 4 | July 6th 04 12:22 AM |
| IGC File Fix for Cambridge GPS NAV? | Jim Vincent | Soaring | 6 | March 27th 04 09:03 PM |
Threaded Mode