|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 11th 15, 04:23 PM
posted to rec.aviation.soaring
|
|||
|
|||
Spring prepapration advice
The corner of my Ventus landing gear door got bent and needs to be glued back to its former shape.
What epoxy should I use (I need a very small amount) Need to clamp the piece while drying. What material to use so the clamp doesn't stay glued to the door....? Dan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DISCUS B Gas Spring | Mike J. | Soaring | 1 | May 18th 14 01:52 PM |
| Canopy gas spring LS4, USA | [email protected] | Soaring | 3 | October 30th 12 01:01 PM |
| spring trim metrics | Brad[_2_] | Soaring | 2 | February 2nd 09 02:48 PM |
| TOST Tow Spring Pad for Cub | [email protected] | Soaring | 0 | January 21st 08 05:08 AM |
| Windsocks , Spring Special | GASSITT | General Aviation | 0 | April 2nd 04 04:05 PM |
Threaded Mode