|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
March 11th 15, 10:25 PM
posted to rec.aviation.soaring
|
|||
|
|||
Spring prepapration advice
Agree. ACP is good stuff. They sell everything he will need from mylar to peel-n-ply, glass and excellent laminating resin. This is all aircraft grade stuff in reasonable quantity. While MGS is the best, its only available by the gallon from Aircraft Spruce. going this route, fix it once and be done.
May want to post-cure too. But with either hobby grade epoxy or CA+kicker(quick fix), likely not a lasting fix IMO. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DISCUS B Gas Spring | Mike J. | Soaring | 1 | May 18th 14 12:52 PM |
| Canopy gas spring LS4, USA | [email protected] | Soaring | 3 | October 30th 12 12:01 PM |
| spring trim metrics | Brad[_2_] | Soaring | 2 | February 2nd 09 01:48 PM |
| TOST Tow Spring Pad for Cub | [email protected] | Soaring | 0 | January 21st 08 04:08 AM |
| Windsocks , Spring Special | GASSITT | General Aviation | 0 | April 2nd 04 03:05 PM |
Threaded Mode