![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#28
|
|||
|
|||
![]()
Anyone out there managed to install a 406 ELT on a standard category C of A glider with the proper paperwork from the maintenance shop? Just wondering because they all seem to have specs for ground plane dimensions that are incompatible with non-metal gliders. The Kannad referred to earlier specifies a minimum antenna ground plane radius of 24 inches for example.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Glider Crash in CA | Tom (2NO) | Soaring | 27 | September 9th 16 04:26 AM |
Glider Crash in Shirley, NY | [email protected] | Soaring | 15 | May 7th 13 09:23 PM |
Littlefield, Tx Glider Crash | LongJourney | Soaring | 2 | May 2nd 13 03:50 AM |
Scottish Glider Crash | Mike the Strike | Soaring | 22 | July 16th 06 11:00 PM |
Glider/Skydiving Crash | dm | Soaring | 0 | September 27th 03 05:13 PM |