![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
![]()
On Thu, 30 Jul 2015 10:31:06 -0700, lemonsorbie wrote:
Hi Evan, as I dig into Borgelt more and more......agreed! Bloody annoying. Hmmmm may need to consider options. I think the Tasmin V1000 is also worth a look. Our club Puchacz has one installed. As I've been known to go soaring solo in the Puch, I've paid the Tasmin a fair amount of attention. Its noises are nice and its response rate is good. It uses a circular LCD display with series of blocks round the edge that show in sequence so you read it like an analogue dial. There is a digital averager readout in the screen centre. Nothing to fiddling with either: the only controls are on/off and a pair of buttons for volume control. I've also helped a clubmate install a V3 in his glider. It seems quite a nice instrument and easy to read, but for two points: (1) its set-up menu is a bit of a fiddle (2) its noises are irritating, the more so because there's no option to have silent deadband around zero (or wasn't with that firmware version). The only choices were silence or a continuous drone from zero sink on down and it used a tone that would get on my nerves. -- martin@ | Martin Gregorie gregorie. | Essex, UK org | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Butterfly vario side-by-side with ClearNav vario | [email protected] | Soaring | 30 | May 22nd 13 07:11 AM |
What vario is this? | [email protected] | Soaring | 6 | December 6th 12 11:30 PM |
WTB: 57mm Cambridge Vario/FS: 80mm Cambridge Vario | ufmechanic | Soaring | 0 | March 24th 09 05:31 PM |
TE vario | G.A. Seguin | Soaring | 8 | June 8th 04 04:44 AM |
WTB LD-200 Vario | Romeo Delta | Soaring | 0 | June 4th 04 03:08 PM |