|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#19
November 15th 15, 10:24 PM
posted to rec.aviation.soaring
|
|||
|
|||
Urethane Paint
PU does seal that surface up better, mostly because it seals up the porosity in the gelcoat as well as being a much better UV barrier. UH UH...Curious as to the factory steps taken to apply a PU finish. Is everything the same (same gelcoat, same thickness, same sanding, same prep, et cetera sans waxing) then the wing is taken to a paint booth and sprayed like a car? After spray painting, are the wings sanded or "rubbed" in any way? What is the current "favorite" maintenance wax or polish for factory finished PU? Thanks for your response. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| urethane 2K paint | [email protected] | Soaring | 1 | February 4th 14 11:30 PM |
| Paint job W&B | Dan Luke | Owning | 2 | March 31st 07 12:03 AM |
| paint | [email protected] | Soaring | 9 | March 7th 06 09:22 PM |
| Paint | Steve | Owning | 17 | January 8th 06 08:54 AM |
| hi vis Paint | Ben Haas | Home Built | 0 | November 8th 03 02:58 PM |
Threaded Mode