|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#24
November 17th 15, 01:38 PM
posted to rec.aviation.soaring
|
|||
|
|||
Urethane Paint
There is typically filler along the leading edges where the two halves of the wing were joined. Also, your particular LS3 had some profiling work done in the area of the spar; is that where this additional material was found?
Currently have a 1984 LS4 on the operating table... p3 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| urethane 2K paint | [email protected] | Soaring | 1 | February 4th 14 11:30 PM |
| Paint job W&B | Dan Luke | Owning | 2 | March 31st 07 12:03 AM |
| paint | [email protected] | Soaring | 9 | March 7th 06 09:22 PM |
| Paint | Steve | Owning | 17 | January 8th 06 08:54 AM |
| hi vis Paint | Ben Haas | Home Built | 0 | November 8th 03 02:58 PM |
Threaded Mode