|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
April 14th 16, 01:22 AM
posted to rec.aviation.soaring
|
|||
|
|||
Do L'Hotellier Ball Fittings Wear?
In Australia AD177 covers L'hotellier couplings. 1000hr replacement for shanks under 6mm, 3000hr for others on flap and dive brake circuits. 0.1mm max difference between different axes of ball at 90 degrees to each other - like an X through the cross section (best to look at the diagram!). Lubrication each rigging, 50hrs and 6 months. There's a bunch of other stuff in there too, but not sure how much is Oz specific vs out of manufacturer ADs.
Cheers Ben 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Source of L'Hotellier Fittings? | Six-Seven Romeo | Soaring | 2 | September 1st 15 06:33 PM |
| Brass Compression Fittings,Fittings for Pex-Al-Pex Sale on good price | valvetom | Piloting | 0 | November 27th 06 06:58 PM |
| L'Hotellier | [email protected] | Soaring | 5 | September 9th 05 05:21 PM |
| wanted L'Hotellier ball fitting assembly | Udo Rumpf | Soaring | 3 | January 7th 05 04:05 AM |
| Hotellier connections | Mike | Soaring | 38 | September 28th 04 05:30 PM |
Threaded Mode