![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#8
|
|||
|
|||
![]()
The devil is in the details......
WD-40 can be great to dry out some electrical bits, as well as loosen dried lube (grease and/or oil) or loosen rusted iron bits. It has, basically, NO lubrication in it, so......it can get things moving, but likely NOT keeping them moving. I use about 12 different lubes, depends on the application, currently I like "fluid film" as it sticks, works well and is limited in negative effects due to temp. Silicone spray when I'm dealing with rubber or similar. LockEze for cables, locks or small parts since it's basically graphite. Yes, WD-40 can free it up, but it WILL fail again due to lack of a real lube. Taken from a "mechanical guy" of over 40 years, doing facilities maintenance and auto/aircraft during that time. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spoilers, no spoilers? | Amine | Piloting | 39 | February 14th 08 02:37 AM |
Flaps/spoilers on which sailplanes? | [email protected] | Soaring | 11 | December 31st 06 01:12 AM |
spoilers vs. ailerons | [email protected] | Piloting | 36 | August 8th 05 11:24 AM |
Frozen spoilers | stephanevdv | Soaring | 0 | November 4th 04 05:24 PM |
L-13 Spoilers | Scott | Soaring | 2 | August 27th 03 06:08 AM |