![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]()
Sorry, I've scoured my hangar and can not find the switches I offered to
give away. I must have given them away to the person who bought my last glider. Dan On 10/21/2016 9:25 AM, Dan Marotta wrote: I have a complete system, never installed, that I picked up somewhere back in the early 90s. It includes two micro switches, a battery connector for a 9-v radio battery, a piezo horn, and an ON/OFF switch. It's all wired together, but can be taken apart to use a switch in your own installation. Frankly, I'd wire it into ship's power without a switch. Just one more thing to forget. Send me your address and I'll send it to you for free (assuming I can locate it, I think I know where it is). I'll need postage if you're not in the US. Dan On 10/20/2016 6:48 PM, HGXC wrote: On Thursday, October 20, 2016 at 12:48:44 PM UTC-4, HGXC wrote: I broke the gear up warning trip switch on my glider. It was positioned near the landing gear mechanism and had a wire that actuated a warning sound. Des anyone know a source for a replacement? Thanks, Dennis DC My current set up is for a micro. I was just going to duplicate what was there. I'm not sure how to set up the reed? Dennis DC -- Dan, 5J |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASW-20C Gear Warning Switch Placement | Jim Kellett | Soaring | 3 | May 16th 09 01:20 AM |
Stall warning switch for Cessna 206? | [email protected] | Owning | 1 | February 20th 07 09:16 PM |
Gear Warning | Gadget Guy | Soaring | 118 | November 30th 05 10:43 PM |
Gear Warning | Gordon Schubert | Soaring | 11 | November 22nd 05 03:27 AM |
gear warning plus | K.P. Termaat | Soaring | 0 | September 8th 03 08:33 AM |