|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
December 13th 16, 10:22 PM
posted to rec.aviation.soaring
|
|||
|
|||
JS3 chatter
Would be interested to know details of four tubing connector fittings required to "plumb" the probes in the tail each assembly and disassembly sequence. Surely its not a "press tubing onto a barbed in-line connector" process. Thinking it would be a two person job...one to balance the horizontal and the other to connect the fittings. Better yet...you assemble once at beginning of contest, tie out every night, and disassemble once at end of contest. Awh... the convenience of good weather, a sustainer, poly paint, and good covers. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cockpit Chatter and Groundcrew Gripes | Andie Ankey-Upcuff | General Aviation | 1 | June 9th 05 02:57 AM |
Threaded Mode