|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 21st 16, 01:48 AM
posted to rec.aviation.soaring
|
|||
|
|||
Flarm/ClearNav Help Needed
Hi All,
I built a cable for My Power FLARM portable according to the drawing on the Tech Tips portion of the ClearNav site but The CN does not connect to the Flarm. I have a cable tester and the cable checks good. I've tried baud rates from 19.2 to 57.6K and still no luck. I also spoke with another CNII user at Moriarty and he asked me if I'd enabled FLARM on my CNII. I've looked and can't find anything other than Flarm Status - There is none, and Flarm Alerts and I have the longest alerts selected. What about the Flarm dataport strings? Flarm Only or Flarm and Nav (I've tried it both ways without success)? Does anyone have any other suggestions? -- Dan, 5J 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| trying to work out how you connect the flarm view 57 to mini box flarm running a V7 and Oudie | Michael Marshall[_2_] | Soaring | 3 | April 10th 16 05:13 AM |
| trying to work out how you connect the flarm view 57 to mini box flarm running a V7 and Oudie | Michael Marshall[_2_] | Soaring | 0 | April 8th 16 09:57 PM |
| Information for all users of Flarm, OEM FLARM supplier and Flarm PowerFlarm | [email protected] | Soaring | 28 | March 12th 16 05:31 AM |
| Integrating Flarm with Clearnav | [email protected] | Soaring | 8 | September 6th 12 02:33 PM |
| Help needed: ILEC SN10 pilots with FLARM | Dave Nadler | Soaring | 2 | December 1st 09 01:03 AM |
Threaded Mode