If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
Pin holes (again)
On Tuesday, April 4, 2017 at 11:56:12 AM UTC-4, wrote:
On Tuesday, April 4, 2017 at 10:53:46 AM UTC-4, wrote: Go with Hanks advice. He guided me in the refinish of CF and it turned out great. I was constantly advised by spectators as to how I "should do it". One guy grabbed a gear foot and promptly sanded through to the foam core.. From then on I didn't mind being rude to the next neighbor with the "better idea". In short, don't make it complicated. Simtec also has a filler if you are using their products. Lane Simtec 2081 does not sand anywhere as well as Polyprimer. JJ put me on to Polyprimer. UH 2081 sands fine if you add a little gelcoat. i'd be interested to try polyprimer sometime. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Where do main pin holes come from? | Bob Kuykendall | Soaring | 17 | November 2nd 10 11:02 PM |
Mystery holes. | Monk | Piloting | 16 | January 2nd 09 04:43 AM |
Covering holes | [email protected] | Soaring | 9 | May 2nd 08 05:57 PM |
When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 01:19 AM |
Filling Holes | AKperson | Owning | 1 | July 20th 05 03:54 PM |