|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#19
April 9th 17, 02:34 PM
posted to rec.aviation.soaring
|
|||
|
|||
Pin holes (again)
I have done it both ways, but prefer polyprimer because it is white!
Another tid-bit I have tried is to wet sand with 800 grit after 12 to 24 hours cure, then buff out right away. Shines like no tomorrow, believe the paint is moving under buffer, just enough to eliminate the 800 sand marks. JJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where do main pin holes come from? | Bob Kuykendall | Soaring | 17 | November 2nd 10 11:02 PM |
| Mystery holes. | Monk | Piloting | 16 | January 2nd 09 04:43 AM |
| Covering holes | [email protected] | Soaring | 9 | May 2nd 08 05:57 PM |
| When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 01:19 AM |
| Filling Holes | AKperson | Owning | 1 | July 20th 05 03:54 PM |
Threaded Mode