|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
September 25th 17, 04:25 PM
posted to rec.aviation.soaring
|
|||
|
|||
Removing oxidation from Cobra trailer trim rubber and plasticfenders
Curious - why blue instead of red?Â* Something to do with solar radiation?
On 9/25/2017 7:40 AM, wrote: I did what Roy did, knock off the crud with wire brush and 80 grit sandpaper, then mask and shoot with rattle-can, changed to blue. I used 2" tape on top and a 3 foot piece of cardboard below the lip.......spraying 2 foot at a time with the can aimed down 45 degrees. I'm buffing the glass top now.......good winter projects. JJ -- Dan, 5J 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra trailer trim | [email protected] | Soaring | 11 | September 5th 13 03:54 PM |
| Cobra trailer wing dolly plastic sidewall rollers? | [email protected] | Soaring | 4 | May 9th 13 10:52 PM |
| plastic or metal fenders on the trailer? | chris | Soaring | 14 | December 20th 10 09:51 PM |
| Cobra trailer trim. | Bob | Soaring | 12 | July 19th 06 05:12 AM |
| Help - Cobra Trailer Trim? | WDM | Soaring | 2 | January 12th 05 07:47 PM |
Threaded Mode