|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
September 29th 17, 09:03 PM
posted to rec.aviation.soaring
|
|||
|
|||
transfer/ doublesdied tape.
John,
It's not the tape.........it's the surface preparation and cleaning prior to application. I sand both the Mylar (inside 10mm) and the wing area where the stickie stuff goes. Then wipe both surfaces and the Mylar with acetone just before application. Search this site for gobs of info on this subject. JJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| high-stregth transfer tape | Paul Gaines | Soaring | 4 | April 18th 15 07:14 AM |
| Transfer of IGC log for contest scoring | Tom N. | Soaring | 22 | February 21st 07 09:15 PM |
| Technology transfer? | Rich S. | Home Built | 4 | June 30th 05 06:58 PM |
| Transfer registration from Canada to US | joe | Rotorcraft | 2 | June 24th 04 12:58 PM |
| Fuel Transfer Placards | Ben Smith | Owning | 22 | October 16th 03 02:32 PM |
Threaded Mode