![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#23
|
|||
|
|||
![]()
On Sunday, December 31, 2017 at 6:13:39 PM UTC-6, Steve Koerner wrote:
On Sunday, December 31, 2017 at 3:13:42 PM UTC-7, Dan Marotta wrote: If it's not too much trouble, try a coax cable length of 21 11/16 inches which would be 2 wavelengths at 1090 MHz (assuming my arithmetic is correct).* You may have reflected power in your coax which will reduce performance. Dan: I'm not jumping into the real technical matters here but its pretty obvious that you're neglecting the fact that waves travel slower in coax. Hey Dan, I think you may be correct about Too short, I googled this and there is a couple of opinions that seem to originate with Garmin, I doubt very many transponders are installed with coax runs less than 15 inches, maybe this particular problem is rare? I'm using rg400, and may try a longer coax run. Thanks, Scott. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASW27 Fuselage Tank | Ross Drake | Soaring | 1 | April 25th 13 10:58 AM |
ASW 27 or 27-18 406 ELT & antenna installation | chipsoars | Soaring | 6 | October 10th 09 04:07 PM |
Rust prevention: Inside fuselage | Michael Horowitz | Home Built | 10 | August 20th 07 10:33 PM |
FLARM antenna installation | Kevin Neave | Soaring | 5 | January 16th 07 06:53 PM |
Looking for an ASW27/28 fuselage | goneill | Soaring | 0 | May 23rd 04 08:41 PM |