|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
April 10th 18, 01:44 PM
posted to rec.aviation.soaring
|
|||
|
|||
Source of green donuts for instrument tubing installation?
On Monday, April 9, 2018 at 3:05:36 AM UTC-4, wrote:
Using them prevents leaks later on, clamping the tubes. Has anyone ever tried a short piece of shrink-sleeve - no longer than the barbed fitting on the instrument - over the tubing? Slip it into place and hit it with a hot-air gun. Should shrink uniformly before doing damage to the tubing. Uli 'AS' 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pvc tubing/sleeve source? | Jim Burns | Owning | 4 | September 28th 06 03:36 AM |
| pvc tubing/sleeve source? | Jim Burns | Home Built | 4 | September 28th 06 03:36 AM |
| Recommended source for 4130 sheet and tubing? | Michael Horowitz | Restoration | 3 | April 16th 06 07:23 PM |
| source for clear+red instrument tubing | John W | Soaring | 8 | November 1st 04 01:19 PM |
| source for aluminum tubing with rounded corners? | Kyler Laird | Home Built | 3 | June 1st 04 03:07 PM |
Threaded Mode