![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
![]()
On Monday, September 24, 2018 at 1:41:26 PM UTC-7, Valentin Mayamsin wrote:
I've recently purchased a used Cobra wing rigger. Though it doesn't seem to fit my Jantar Std 2 wings -- it's certainly made for wider wings. I'd like to offer it for sale and would like to identify its size and which wings it is designed for. All I know is the rigger cuff will go from 30 3/4 inches to 39 inches chord (780mm to 990mm). Please advise. Thank you, -Valentin I've seen the glider type labeled on the wing cuff of Cobra riggers. The one I use with the 29 came with a 27, but was labeled ASH25 (molded into the lower surface of the main composite part). We modified the leading edge of that one to work with thinner wings. If the leading edge is the tricky bit, perhaps you can do the same to make it fit the Jantar? Jim |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking for a wing rigger for an asw 20 | Marcin S | Soaring | 1 | July 10th 17 02:21 AM |
Ka6 wing rigger | James Koper | Soaring | 2 | June 22nd 17 03:23 PM |
Wing Rigger | Dan Marotta | Soaring | 2 | September 3rd 16 02:54 PM |
Wing Rigger FS | Ron Gleason | Soaring | 2 | December 5th 13 05:36 PM |
Looking for a used wing rigger / one man rigger .... | [email protected] | Soaring | 0 | November 6th 13 06:02 PM |