![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
![]()
Terrible point to jack from. Puts stress on the floor, sidewall and suspension. Jack should always be placed under the axle itself. Plus you don't have to lift more than a few inches to get the tire off the ground. Jacking up the "box" requires you to lift it high enough for the suspension to extend fully. Don't do it again!
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cobra Trailer Screw Jack | [email protected] | Soaring | 0 | November 20th 12 04:18 PM |
Cobra Trailer Screw Jack | JS | Soaring | 0 | November 20th 12 02:01 AM |
Cobra Trailer Screw Jack | Mike McCarron[_2_] | Soaring | 4 | July 31st 12 09:07 PM |
Cobra Trailer Screw Jack | Mike McCarron[_2_] | Soaring | 0 | July 30th 12 07:27 PM |
WTB: Cobra Trailer Ramp Jack - US | Gary Emerson | Soaring | 1 | June 21st 09 01:34 AM |