|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#34
November 11th 18, 07:45 AM
posted to rec.aviation.soaring
|
|||
|
|||
Refinishing Ventus b Fuselage
Richard,
How did you determine to use the aft wing locating pin bearings for mounting on your rotisserie? I'm just at that stage in building one for my Ventus. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| refinishing Ventus 2cm- wing profile | [email protected] | Soaring | 20 | November 6th 11 12:15 AM |
| refinishing | Stig Pedersen | Soaring | 1 | November 27th 05 04:50 PM |
| refinishing | Stig Pedersen | Soaring | 1 | November 26th 05 09:16 PM |
| Second speaker in Ventus 2b/c fuselage | [email protected] | Soaring | 3 | September 14th 05 05:41 PM |
| REFINISHING | Ventus B | Soaring | 32 | December 3rd 03 10:14 PM |
Threaded Mode