![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]()
On Tuesday, January 15, 2019 at 7:47:50 AM UTC-8, Dan Marotta wrote:
I think I had those on my '19 and they could be locked in the blind. The Walmart pins were cheap, about $0.16 each, do the job, and in two years not one has come out in service.Â* They're attached to the aileron control rod by a length of waxed string.Â* YMMV.Â* Of course the Stemme clips are visible during installation, no reaching through a hole to install them.Â* I use a hemostat as a tool to help my clumsy fingers get the pin installed. On 1/14/2019 8:32 PM, wrote: T8 is correct. Fit correctly and easy to use. -- Dan, 5J But of course any random metal "thingy" purchased from the great American institution Walmart should be considered flight worthy without question or test. Call me about some ocean front property I have for sale ![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Do L'Hotellier Ball Fittings Wear? | Casey[_2_] | Soaring | 32 | April 15th 16 08:04 AM |
Source of L'Hotellier Fittings? | Six-Seven Romeo | Soaring | 2 | September 1st 15 05:33 PM |
l'Hotellier on EB28 | rlovinggood | Soaring | 5 | January 27th 08 11:32 AM |
L'Hotellier | [email protected] | Soaring | 5 | September 9th 05 04:21 PM |
Hotellier connections | Mike | Soaring | 38 | September 28th 04 04:30 PM |