|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 16th 19, 01:59 AM
posted to rec.aviation.soaring
|
|||
|
|||
Filling small holes in panel?
On Saturday, December 7, 2019 at 5:12:08 PM UTC-6, soaringjac wrote:
Any recommendations on what to use to fill small holes in an aluminum panel? My preferred method is to make a new panel. at least as long as the original was flat plate aluminum. The classic gliders I can afford (SHK, Std Cirrus, Phoebus, Grob 103) all have had aluminum plate panels, usually pretty ragged from multiple instrument changes over the years and making a new one only takes 3 or 4 hours and I can put the instruments where I want. Of course a band saw and drill press make this possible in my case. Good Luck, Scott 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to determine if your ASG29 has the large or small panel? | Sean Fidler | Soaring | 37 | November 19th 14 06:50 PM |
| Trying to fill some holes in the instrument panel | [email protected] | Soaring | 2 | February 12th 14 02:55 AM |
| Cutting 57mm holes in the instrument panel.....how to? | John Bojack[_2_] | Soaring | 20 | November 12th 10 09:15 PM |
| When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 01:19 AM |
| Filling Holes | AKperson | Owning | 1 | July 20th 05 03:54 PM |
Hybrid Mode
