![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
|
|||
|
|||
|
I had the same issue recently with my LS7. Per another suggestion on RAS, I ordered a replacement from LS Technologies in Canada ( www.lstechnologies.ca ). They will need to know the pressure rating, center to center extended length, rod diameter, and size of the end holes (diameter and length). My replacement was $38 CAD plus shipping. The replacement did not have bearings in the end holes, but installs easily and works fine.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LS8 Canopy Strut Replacement | [email protected] | Soaring | 2 | September 10th 19 02:40 AM |
| Trailer Tongue Gas Strut replacement | Colin Mead | Soaring | 2 | May 18th 12 04:17 PM |
| replacement gas strut for wing wheel | Frank[_12_] | Soaring | 6 | April 27th 10 05:20 PM |
| Gas Strut- SZD-59 Canopy? | sisu1a | Soaring | 4 | December 11th 09 05:53 AM |
| Cherokee Strut Lower Strut Seal Replacement Report | Mike Spera | Owning | 3 | July 23rd 05 08:07 PM |