|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 18th 03, 07:59 AM
|
|||
|
|||
Drag of LS3 compared LS3a.
Dick Johnson found that the LS3a he tested, had a
higher sink rate over the whole polar, relative to the LS3. He found the 'a' version to have a 6mm thicker airfoil. Was this just a specific aircraft difference, or are all LS3a's systematically inferior to the LS3's? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| max altitude and Mach 1 | Boomer | Military Aviation | 22 | June 1st 04 09:04 PM |
| Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 07:42 PM |
| Lower Drag: Rounded or Sharp? | Jay | Home Built | 9 | May 10th 04 11:30 PM |
| Angle of climb at Vx and glide angle when "overweight": five questions | Koopas Ly | Piloting | 16 | November 29th 03 11:01 PM |
| Forward CG Experience | Jay Honeck | Piloting | 41 | November 19th 03 03:54 PM |
Linear Mode
