|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 4th 07, 06:16 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Making plastic parts
"Lou" wrote...
Does anyone know of a material that starts as a liquid, but hardens as a platic? I want to make some custom plastic parts for my plane (no not for the structure) that will require making a mold and then pouring in the liquid. About thirty five years ago, back when the EAA still cared about homebuilt aviation, there was a good article in Sports Aviation about forming plastic sheet into complex shapes for interior trim pieces. Rich 
|
|
#2
September 4th 07, 12:07 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Making plastic parts
What!?!? The Expensive Aircraft Association was once about homebuilts?
 Scott http://corbenflyer.tripod.com/ Gotta Fly or Gonna Die Building RV-4 (Super Slow Build Version) Richard Isakson wrote: About thirty five years ago, back when the EAA still cared about homebuilt aviation, there was a good article in Sports Aviation about forming plastic sheet into complex shapes for interior trim pieces. Rich --
|
|
#3
September 4th 07, 07:47 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Making plastic parts
Scott wrote:
What!?!? The Expensive Aircraft Association was once about homebuilts? way back in once upon a time time...
|
|
#4
September 5th 07, 12:11 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Making plastic parts
Wait a minute....wait...wait...oh yes, I do recall that time! Somewhere
about when I joined up back in 1980 or so Scott http://corbenflyer.tripod.com/ Gotta Fly or Gonna Die Building RV-4 (Super Slow Build Version) cavelamb himself wrote: Scott wrote: What!?!? The Expensive Aircraft Association was once about homebuilts? way back in once upon a time time... --
|
|
#5
September 5th 07, 11:06 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Making plastic parts
On Mon, 03 Sep 2007 04:34:02 -0700, Lou wrote:
Does anyone know of a material that starts as a liquid, but hardens as a platic? I want to make some custom plastic parts for my plane (no not for the structure) that will require making a mold and then pouring in the liquid. Lou Check this out. http://www.reynoldsam.com/ --Andy Asberry-- ------Texas-----
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pirep on replacing interior plastic parts | [email protected] | Owning | 1 | April 12th 05 05:06 AM |
| Plastic Interior Parts? | Mike Spera | Owning | 16 | March 30th 05 08:35 PM |
| Repairing Plastic Interior Parts of 40-year-old Aircraft | jls | Home Built | 6 | December 7th 04 10:04 PM |
| 172 plastic interior parts | G.R. Patterson III | Owning | 9 | May 28th 04 10:28 PM |
| Cessna 172 interior plastic parts | [email protected] | Piloting | 3 | February 11th 04 04:19 AM |
Hybrid Mode
