|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 7th 10, 04:47 PM
posted to rec.aviation.soaring
|
|||
|
|||
Skin for Blanik wing
On May 7, 3:43*am, Dave Nadler wrote:
PS: *Are you going to do an analysis of the rivets as well ? Composition, taper, hardness, etc ? For the hopelessly curious... Dave, I'm not going to do that at this time. The wreck that I'm getting the skin sample from doesn't have any riveted parts that are so badly smunched that their removal would have zero impact. If somebody out there does have a bit of flush-riveted Blanik wing wreckage, I'd be glad to cross-section a couple of the rivets so we can get an idea of the joint geometry. Thanks, Bob K. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blanik L-23 Super Blanik Manual -F.C.F.S. | Joel Flamenbaum | Soaring | 2 | April 14th 10 04:29 PM |
| Blanik L-23 right wing needed | Greg Arnold[_2_] | Soaring | 1 | February 22nd 09 06:08 PM |
| PA28-235 pilot-side wing top skin cracking question.... | USA | Piloting | 7 | June 2nd 06 02:08 PM |
| Finding vent hole in wing skin | Martin Eiler | Soaring | 7 | November 21st 03 02:44 PM |
| Wanted: Left wing for Blanik L 13 | Rich Chesser | Soaring | 1 | July 19th 03 06:52 AM |
Hybrid Mode
