|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 30th 03, 06:47 AM
|
|||
|
|||
With a PU finished glider, how do you deal with the spar cap shrinkage problem?
|
|
#2
October 30th 03, 08:51 PM
|
|||
|
|||
|
On 29 Oct 2003 22:47:59 -0800, (Liam Finley) wrote:
With a PU finished glider, how do you deal with the spar cap shrinkage problem? You sand it and paint it again. Around here the glider buyers are getting the wings in gel coat, flying for a season or so, sanding and painting in PU. Mike Borgelt
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Paint Stripper? | PETER H. OUELLETTE | Home Built | 9 | November 30th 04 06:12 PM |
| One coat paint for aluminum? | [email protected] | Home Built | 10 | September 17th 04 07:01 AM |
| Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 07:58 PM |
| Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 05:09 PM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |
Hybrid Mode
