Ventus A and B Wing Root Fairings

wrote:
You described the fairing installation procedure well JJ, and that is
just how I did mine.
But do not forget to describe sawing off the 4 inches of each flap
root. Otherwise it is real difficult to move the flaps.
Dick Johnson

Now I know why I couldn't move the flaps on that Nimbus 3. Considered
trying to get into standard class with it, but as Dick points out, one
must remove the 4" of flap that otherwise would get trapped inside the
fairing. Then plug the open end of the flap and add a fence. I could
play a tune with my Nimbus when just moving the flaps up and
down----Weeeee-----wooooo----wrrrrr-----weeeee. This mod stopped all
that, quiet is good, right Dick?

As for the Nimbus 2 or other ships, I would consider adapting an
existing fairing to match your ship (cut and paste, trim and adapt)
Making a fairing from scratch involves a lot of up-side-down work with
urethane foam dust falling into your eyes. Most modern airfoils have a
similar curve. I did something on these lines to a 301 Libelle about
100 years ago, then made a hinged canopy, she was a hummer.
JJ

Look in the June issue of Soaring for 2 photos of the Ventus A wing
root fairings.
Fairings should about equally benefit the Nimbus 2, but that wing is
thicker, and I do not know if anyone has developed fairings for it.
Dick Johnson

I found an image on Jim Phoenix's site of the fairing.

http://www.jimphoenix.com/jimphoenix...Nfuselage.html

Also the last issue of Soaring Magazine has a good picture from the
rear of Dick's Ventus with the wings on so you can see the flaps.

"JJ Sinclair" wrote in
oups.com:

I could
play a tune with my Nimbus when just moving the flaps up and
down----Weeeee-----wooooo----wrrrrr-----weeeee.


Hey JJ, my PIK-20d played the same tune. Were they in the same band?
-Bob Korves

Dick,

I looked at my Ventus tonight and I see that the flap drive is about
two inches inboard from the end of the flap, but about four inches will
need to be cut off. How did you deal with the flap connection hardware
when you trimmed the flaps? At the upper (connection) end of the flap
is there enough room that you do have to change anything?

Thanks,

Tim

Hi Tim,
No hardware needs to be changed to install the wing root fairings,
and shortening the flap roots is easy.
Dick Johnson

I stll have the moulds for the fairing kit for Ventus B.

If anyone would like to cover my costs ($1200) on them I would be happy
to part with them.

Regards

Al

Al,
Please email me off list at

I am interested in the fairing moulds.

(Please renome the _no_spam from the email address.

Cheers

Mark


wrote:
I stll have the moulds for the fairing kit for Ventus B.

If anyone would like to cover my costs ($1200) on them I would be happy
to part with them.

Regards

Al