If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
Mechanics of Elevator Trim. In Detail.
On Jun 9, 1:19*pm, Gig 601Xl Builder
wrote: Le Chaud Lapin wrote: MSFS was the means by which I discovered the mechanism. If I had learned in actual aircraft, the question still would have been relevant. -Le Chaud Lapin- You never learned of trim until MSFS and you are going to design an airplane. Fabulous! Is it really necessary to understand the particular way it was done in C172 to achieve the same result? The same thing could be achieved using more electronics, less mechanics, and the controls might be entirely different. -Le Chaud Lapin- |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
F-100 detail | Pjmac35 | Aviation Photos | 0 | July 26th 07 10:29 AM |
Finding "Neutral" Position on Piper Elevator/Trim Tab | [email protected] | Owning | 10 | December 7th 06 01:43 PM |
Detail pops in too late in FS2004 | CatharticF1 | Simulators | 0 | August 27th 03 03:25 AM |