If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Alternator noise on Xmit only
On Jul 1, 6:34*pm, David Lesher wrote:
"Mike Noel" writes: So running a grounding wire from the jack to the radio tray is not enough? You want to isolate the jack from the panel ground. -- A host is a host from coast to & no one will talk to a host that's close........[v].(301) 56-LINUX Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433 He's right you know. Otherwise, small alternator induced voltage drops in the airframe will show up in series with the mic. You puny little wire won't change that picture. Isolation washers are the answer!! Should be on the phones too. Bill Hale |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FAA paper Noise Attenuation Properties of Noise-Canceling Headsets | Jim Macklin | Piloting | 26 | January 13th 07 12:06 AM |
FAA paper Noise Attenuation Properties of Noise-Canceling Headsets | Jim Macklin | Instrument Flight Rules | 15 | January 13th 07 12:06 AM |
Alternator Noise -- Part 2 | Jonathan Goodish | Owning | 0 | December 11th 04 04:10 AM |
Alternator Noise | Jonathan Goodish | Owning | 17 | December 10th 04 04:29 AM |
Alternator field cycling & alternator damage | Nathan Young | Owning | 7 | November 14th 04 09:02 PM |