|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 29th 13, 09:00 PM
posted to rec.aviation.soaring
|
|||
|
|||
EE help please - - locating Schottky diode
Want to install Schottky diode Mouser part# 844-95SQ015 http://www.mouser.com/ds/2/427/95sq015-27345.pdf in all 3 of my battery supply lines.
Setup is spar-shelf batteries "+" side through 5 amp flat auto fuse Anderson PowerPole connectors + and - wire under seat-pan all 3 "+" through panel mounted on/off switch positive terminal block with entire input side "jumped". All 3 "-" battery leads go to negative terminal block with entire input side "jumped". Where is the proper place to locate the diodes? Which way will the diode ring orientate? On the negative terminal block, should there also be a ground wire run to the elevator/aileron yoke? Thanks. Ben 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help Locating a Camloc Latch. | Ebby | Home Built | 1 | October 20th 06 02:36 AM |
| Battery Contactor Diode? | Skrud | Home Built | 25 | September 11th 06 06:17 PM |
| Need Help Locating Owner | Ross | Owning | 2 | April 3rd 06 05:30 PM |
| locating Jiran | Paul Gaines | Soaring | 0 | December 9th 05 11:57 PM |
| Locating Gas Pumps at Airports FS2004 | Arthur Alspector | Simulators | 5 | March 13th 04 10:32 PM |
Threaded Mode