If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Flying on the Cheap - VOX
VOX - - Voice-Operated Xmitter (ie, transmitter) - - is often favored among those who dangle under the wings they fly. The Maxon PTT/VOX model CA-1482A, which is known to work with most Icom and Yaesu HT's, is presently being offered for $3.50 as new-surplus by All Electronics (www.allelectronics.com) Their catalog # is VOX-2. The Maxon CA-1482A is a well designed unit that uses a combination of SMT and traditional components. It is powered by an internal, rechargeable NiCad cell that is recharged in a novel manner. The standard Maxon wall-wart, their CA-1410D, delivers 14.5vdc @ 60mA via a 2.5mm phone plug, designed to recharge the Maxon SP- and CP-5000 radios. But by plugging the wall-wart into the MICROPHONE jack of the CP-1482A, the 14.5vdc is fed through a series of diodes and dropping resisters so that the NiCad cell sees a suitable voltage for recharging - - which takes about 12 hours, assuming the battery is dead, which it will be when you receive the unit from All Electronics. Just plug it in and leave it over-night before trying to use it. Once charged, the VOX is good for about ten days of normal use. If you don't have the standard Maxon charger (ie, their CA-1410D), All Electronics carries a suitable replacement, their catalog # DCTX-1211 @ $3.00. I originally purchased the VOX module only for the molded dual-plug connector. (!!) At $3.50 the cost of the VOX was less than the price of individual mini-phone plugs and wiring. And while the VOX units I've purchased (four, so far) all worked perfectly well, their primary purpose is to provide an inexpensive source of parts for fabricating aviation head-sets for a gang of youngsters. -R.S.Hoover (KA6HZF) |
#2
|
|||
|
|||
Flying on the Cheap - VOX
Thank you again VW'er,
Unfortunately, all talks of electronics fly right over my head. Off on a slight tangent, I purchased two old military headsets that have helicopter type plugs many years back. What do I need to get these working (being compatible with civil radios)? Something about the mic not being compatible was what I remembered, but I really need a layman's term to understand. I fly choppers, so the one plug thingy fits fine, no need to change to airplane's two plug type, just the mics I think something with impedence? The Monk |
#3
|
|||
|
|||
Flying on the Cheap - VOX
A simple solution would be to go to your local aircraft salvage and pic
up on the cheap a microphone and earphone speakers from a civil headset and transplant them. The impededence of both are a problem, not just the microphone. The microphone simply plugs in but the earphones will require some experince with a 30 watt soldering pencil. "Flyingmonk" wrote in message oups.com... Thank you again VW'er, Unfortunately, all talks of electronics fly right over my head. Off on a slight tangent, I purchased two old military headsets that have helicopter type plugs many years back. What do I need to get these working (being compatible with civil radios)? Something about the mic not being compatible was what I remembered, but I really need a layman's term to understand. I fly choppers, so the one plug thingy fits fine, no need to change to airplane's two plug type, just the mics I think something with impedence? The Monk |
#4
|
|||
|
|||
Flying on the Cheap - VOX
Flyingmonk wrote: I purchased two old military headsets that have helicopter type plugs many years back. What do I need to get these working (being compatible with civil radios)? --------------------------------------------------------------------------------------------- I haven't got a clue :-) Common sense sez the equipment has to fi together in the mechanical sense, meaning your plugs would have to match at some point, and the equipment has to match in the electrical sense, but since I've no idea what the specs are on either end of the system, I've no what you would need to 'get these working.' Using new/surplus ear-phones and mikes to make-up headsets that will work with the typical Icom or Yaesu is duck soup compared to getting two antiques to talk to each other. I've seen some comm gear that still used the PJ-068 jacks & plugs -- stuff that dates from the 1890's(*) -- being copied and fosted off on innocent airman because "We've always done it that way' or other non-sensical reason, as if our next flight will be in a 1937 DC-3, complete with its Detrola radio. -R.S.Hoover (*) -- During the early days of telephone expansion there was some serious competition between Ma Bell and honest people. The 7/32" phone plug came into existance during this time (I think it was introduced by Stromberg-Carlson). Later, it was used by Collins as their microphone plug. |
#5
|
|||
|
|||
Flying on the Cheap - VOX
Flyingmonk wrote:
Thank you again VW'er, Unfortunately, all talks of electronics fly right over my head. Off on a slight tangent, I purchased two old military headsets that have helicopter type plugs many years back. What do I need to get these working (being compatible with civil radios)? Something about the mic not being compatible was what I remembered, but I really need a layman's term to understand. I fly choppers, so the one plug thingy fits fine, no need to change to airplane's two plug type, just the mics I think something with impedence? The Monk Try FlightHelmets.com and get the military to civilian adapter. Worked fine with my VietNam SPH-4 and handheld. Richard |
#6
|
|||
|
|||
Flying on the Cheap - VOX
Worked fine with my VietNam SPH-4 and handheld.
Hey now... That's uplifting. I was hoping that I didn't waste my money on those headsets. They looked very robust. Thank you and all others for answering. The Monk |
#7
|
|||
|
|||
Flying on the Cheap - VOX
In most cases if you have a David Clark headset all you have to do is
change the mic to a civilian type. The electro fet M-7A is the desired mic but the old M1 which is bigger will also work. It will just plug right in to the same plug at the mic. You just have to loosen two set screws at the mic to remove the plug.. I have some friends that used to fly ex-military OH-58's and Bell 206 helicopters also and they tywraped a second mic to the back of the military mic and would rotate the mic around 180 degrees on the ball and socket mic mount on their flight helmets and swap the mic plug to the other mic to change between military and civilian aircraft. For fixed wing aircraft you also need a single plug U-174/U to two plug adapter Y cable. Several places sell these DC PN 18253G-05 including Sporties for about $40. David Clark sells a dual impedance headset H10-66 that has a switch to change between the mil and civilian types. The addition is an internal mic amplifier PN 18911G-01 and a switch. The mil mic is a 4 ohm impedance dynamic (no built in amp]. The civilian mic is a dynamic mic with an internal amplifier so that it looks like an old style carbon mic, the amp is powered by the radio. The earphones are about 150 to 300 ohms in either case. John F On 26 Feb 2006 07:33:16 -0800, "Flyingmonk" wrote: Thank you again VW'er, Unfortunately, all talks of electronics fly right over my head. Off on a slight tangent, I purchased two old military headsets that have helicopter type plugs many years back. What do I need to get these working (being compatible with civil radios)? Something about the mic not being compatible was what I remembered, but I really need a layman's term to understand. I fly choppers, so the one plug thingy fits fine, no need to change to airplane's two plug type, just the mics I think something with impedence? The Monk |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I want to build the most EVIL plane EVER !!! | Eliot Coweye | Home Built | 237 | February 13th 06 03:55 AM |
Flying on the Cheap - Again | [email protected] | Home Built | 9 | January 23rd 05 04:25 PM |
Newbie Qs on stalls and spins | Ramapriya | Piloting | 72 | November 23rd 04 04:05 AM |
good and cheap commercial flying school | hananc | Piloting | 1 | October 23rd 03 04:13 PM |
the thrill of flying interview is here! | Dudley Henriques | Piloting | 0 | October 21st 03 07:41 PM |