If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Pitts Special Steel Tube Fuse Mod.
I'm wanting to lay my seat back further in an existing pitts S1-S. This
would require moving the tube at the top of the seat back, back about 2". This member is 3/4 x 0.035 and about 22" long. I was thinking to run 4" long gussets back to the original attachment point, creating a C shaped section. The problem is that the center of the tube now dosen't line up with the centerlines of the other tubes at the cluster. I know this has been done before but I have no idea how to work out the size needed for the new tube. Does anyone have experience with this? Regards Martin Morgan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pitts Fly-In | aerogirl | Aerobatics | 0 | October 27th 03 11:45 PM |
Pitts, Acro Sport, other to buy? | Dave Swartz | Aerobatics | 0 | September 3rd 03 03:18 PM |
Pitts Special - info and photo's required. | Darryl Gibbs | Aerobatics | 1 | August 5th 03 08:05 PM |