![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Pie ChartsI transferred some third party prop planes from c:/fs2002 in to c:/fs2004. On first loading them into a fs2004 flight I got the 'Shall I get rid of the bits I don't like?' message, to which I responded 'No'.
Thereafter, fs2004 still seems to have gone ahead and trimmed the props off them. OK, OK, accept. BUT, going back into fs2002 the props have also now been trimmed from the same prop planes in fs2002. How does fs2004 edit flight models in C:/fs2002 - there are no common files as far as I'm aware - unless fs2002 is also looking at the fs9.cfg file in Documents and Settings. Any advice on how to get the props back in fs2002 would be very welcome. Regards. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bridges in FS2004 | Kevin Reilly | Simulators | 18 | October 2nd 03 11:00 PM |
FS2004 approaches, ATC etc | henri Arsenault | Simulators | 14 | September 27th 03 12:48 PM |
FS2004 Importing scenery from FS2002 | Twilson | Simulators | 1 | August 13th 03 03:30 AM |