|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 1st 07, 12:17 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
? Screw head diameter?
MS24593 is a flat head machine screw with a 6-32 shank/thread. In this
application the diameter of the screwhead is important. I went to HD and bought a 6-32 machine screw to see what length I needed (the original having rusted beyond recognition). I compared the HD screw with the MS and noticed it was 1/4" dia. as compared to 3/8", so I'm wondering if I order the MS screw if the head will be large enough. The difference I'm seeing is caused by the 100^ angle on the MS screw, but I don't know if the final diameter will match the original. Would anyone with experience with the MS24593 screw please weigh in? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Former Head of 'Star Wars' Program says 9/11 an Inside Job | [email protected] | Piloting | 9 | May 5th 06 12:13 AM |
| Adjustment driver for King VOR head | Robert M. Gary | Piloting | 12 | August 24th 05 06:34 AM |
| Ultralight Club Bylaws - Warning Long Post | MrHabilis | Home Built | 0 | June 11th 04 05:07 PM |
| Archer stabilator jack screw play | Mike Noel | Owning | 7 | June 5th 04 08:02 AM |
| Bothersome Phillips Head Screws | Larry Smith | Home Built | 48 | January 10th 04 04:26 AM |
Threaded Mode