If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Voltage, EDM-700, trim switch follow-up
I wish I could take credit...but can't as the shop at our home field did
the install. I sure like it though. I'd much rather have a hole drilled through an inspection panel under the wing than through the side of the fuselage. Well, give them a pat on the back. It's a much nicer, sleeker, cleaner installation than drilling a big, honkin' 5/8" hole in the side of my plane! -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Voltage variation | Jay Honeck | Owning | 18 | October 3rd 07 09:05 PM |
Electric trim switch -- source? | Jay Honeck | Owning | 19 | August 1st 07 02:06 AM |
Mooney Low Voltage | [email protected] | Owning | 22 | August 1st 05 01:01 PM |
FA: 12V to 24V DC voltage converter | Karl Geng, N1DL | Home Built | 2 | April 21st 05 08:48 PM |
Remote Switch for Pointer ELT --- Why Does It Need Voltage? | jls | Home Built | 1 | November 22nd 04 09:13 PM |