If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Dumb GPS Question
Andrew Sarangan wrote: But you can't ask it to navigate anywhere. In order to compute a route, you have to stand still for a while (for long routes this could take a couple of minutes). In the very least you should stay on one road while it is computing. Since you are obviously not doing any of this while flying, the program will never finish computing the route. My screen just said "computing route" with a progress bar for a very long time. When it seemed like it was getting close to the end, it would start all over again, and the cycle never stopped. My guess is by the time it computed a route, we were far from that position and an entirely new route had to be computed. This may also have something to do with the processing speed of the Dell AXIM. I have seen something similar to this on a number of navigation programs on PDA's. When you go to start a route the software does not allow present position as your starting point, it forces you to give it an address or some other point. Unbelievably stupid. The driving software in the 496 is among the best I've ever seen, a nice suprise. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dumb Question | JohnO | Rotorcraft | 11 | December 24th 06 06:46 PM |
Heres a dumb question | John Huthmaker | Piloting | 12 | March 11th 06 07:44 PM |
Dumb Reg question | John Gaquin | Piloting | 67 | May 4th 05 04:54 AM |
Dumb Transponder Question! | John P | Owning | 2 | March 30th 04 01:26 AM |
Dumb Canard Question. | Russell Kent | Home Built | 39 | October 19th 03 03:25 PM |