|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 29th 04, 01:12 AM
|
|||
|
|||
Lyvoming Crank
Hello
Am looking for a crankshaft for a Lycoming 0-290 D with the thick flange, would consider an engine that has been parted out if the Crank is OK, any help would be appreciated. Phil Lohiser EAA 12873 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ford V-6 engine work | Corky Scott | Home Built | 19 | August 21st 03 12:04 PM |
Linear Mode
