If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#14
|
|||
|
|||
Etching copper clad
RST Engineering wrote:
September '06. Addendum...abrasion with 180 grit sandpaper/cloth does a better and less hazmat job of removing the resist than does lacquer thinner. Jim Duly noted. I'm working on one of the capacitive fuel gauges. You wouldn't happen to have the PCB artwork laying around, perchance? I've started laying it out in gEDA, an open-source design/simulation/production system. "Ernest Christley" wrote in message ... Getting ferric chloride from Radio Shack is getting problematic. Is there a common household chemical that I can use for etching a circuit board or two? I seem to remember Jim Weir having an article about how to do it in the not to distant past, but I can't find anything about it in my back copies of Kitplanes. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Copper in oil analysis ? | [email protected] | Owning | 8 | August 22nd 06 12:31 PM |
Copper in oil analysis ? | [email protected] | Instrument Flight Rules | 8 | August 22nd 06 12:31 PM |
high copper reading in oil analysis | [email protected] | Owning | 1 | March 26th 04 03:32 PM |