|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 12th 03, 06:39 PM
|
|||
|
|||
What's Your Favorite Hand Rivet Squeezer?
I used US Industrial Tool and Supply's hand squeezer to repair trailing
edges and add pma'd bulb on two '56 Cessna flaps. They turned out nicely and two A&P's liked them, but the squeezer was hard to use with 1/8" diameter 2117 rivets. Avery and Tatco sell nice hand squeezers. Avery is better because the handles are longer. 
|
|
#2
November 13th 03, 03:05 AM
|
|||
|
|||
|
Avery Baby!
Veerrrrrrryyy Smooooooth. -- Scott http://corbenflyer.tripod.com/ Building RV-4 Gotta Fly or Gonna Die! "Larry Smith" wrote in message ... I used US Industrial Tool and Supply's hand squeezer to repair trailing edges and add pma'd bulb on two '56 Cessna flaps. They turned out nicely and two A&P's liked them, but the squeezer was hard to use with 1/8" diameter 2117 rivets. Avery and Tatco sell nice hand squeezers. Avery is better because the handles are longer.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
