|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
CFS-1 and CH Yoke / Pedals
I never could get CFS-1 to run well on my old system, it was just too
slow (P-333). So it's languished in the jewel case for a few years...
Recently dug it out and installed it on my 1-gig box - works great!!
But I'm having problems configuring it with my CH yoke and pedals (USB).
CFS recognizes both devices, but won't let me assign or change the
correct axis for each - it assigns pitch, bank, throttle, and rudder to
the yoke; and re-assigns bank again to the pedals.
So, the program is actually recognizing 4 of the 5 yoke axis - pitch,
bank, throttle, and mixture; and it's recognizing 1 of the two rudder
axis, but it won't let me change the assignments.
I've tried to assign the axis manually in the cfs.cfg file, but
something is still awry...any tips? Or a peek at your own config file?
Perhaps I am assuming that CFS supports two devices and it does not?
***remove "spambomb" from address to reply...***
|Thread||Thread Starter||Forum||Replies||Last Post|
|Beech dual yoke w/rams horns/color preference||Dan Karshin||Aviation Marketplace||1||March 28th 04 05:04 PM|
|CH Flight Sim Yoke USB and Pro Pedals USB||nemo||Aviation Marketplace||0||January 27th 04 01:23 AM|
|CH Product Yoke with IP Trainer 6.5||Sanjay Kumar||Instrument Flight Rules||2||October 10th 03 07:47 AM|
|Flight Yoke||Eric Ross||Simulators||2||August 26th 03 09:36 PM|
|FS2004 tail draggers - no rudder pedals - what do I do??||Hogarth Kramer||Simulators||1||August 18th 03 05:43 PM|