|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#21
November 6th 11, 12:15 AM
posted to rec.aviation.soaring
|
|||
|
|||
refinishing Ventus 2cm- wing profile
On Nov 5, 4:14*pm, wladkummer76 wrote:
And be sure to seal it tight... Good point, I'd forgotten about that. Very important. Also, one of those newfangled cockpit exhaust vents can help keep the cockpit air from getting out where it ouhtn't. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interesting biplane project... look at the wing profile | Bob Kuykendall | Home Built | 15 | December 5th 08 01:58 PM |
| Yet Another wing Refinishing question | shkdriver | Soaring | 5 | November 5th 08 11:41 PM |
| LS3A Wing Profile Data | Robert Fidler | Soaring | 14 | October 27th 08 09:59 PM |
| Wing Leading Edge Refinishing | Jan Eldem[_2_] | Soaring | 4 | June 17th 08 02:40 PM |
| ASW27 wing profile templates | basils27 | Soaring | 0 | June 29th 05 11:46 AM |
Linear Mode
