If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Contact cleaning on older Nav radio
I'm pulling out my older RF gear 1 by 1 to use a little Radio Shack contact
cleaner on the interior switches. On my Nav radio I noticed a bank of rotary resistors (guess they are resistors since they are labeled R1, R2 etc.) and I am tempted to treat them and turn the pots back and forth a bit to make sure they're clean. Does anyone know if they are too position sensitive to set back into their original positions by eyeball? Any other comments about using or not using contact cleaner are also welcome. Thanks. -- Regards, Mike |
#2
|
|||
|
|||
"Mike Noel" wrote in message
... I'm pulling out my older RF gear 1 by 1 to use a little Radio Shack contact cleaner on the interior switches. On my Nav radio I noticed a bank of rotary resistors (guess they are resistors since they are labeled R1, R2 etc.) and I am tempted to treat them and turn the pots back and forth a bit to make sure they're clean. Does anyone know if they are too position sensitive to set back into their original positions by eyeball? Any other comments about using or not using contact cleaner are also welcome. Thanks. If these are trim-pots that are mounted inside the radio and aren't normally adjusted during regular radio use, I'd recommend leaving them alone! They shouldn't need cleaning if they aren't moved. The contact cleaner is for cleaning the pots that you use such as the volume control. Are there problems with the radio??? If it ain't broke, keep your f'ing mitts off! Leave it for your avionics tech... |
#4
|
|||
|
|||
On 14-Sep-2003, "Mike Noel" wrote: I'm pulling out my older RF gear 1 by 1 to use a little Radio Shack contact cleaner on the interior switches. On my Nav radio I noticed a bank of rotary resistors (guess they are resistors since they are labeled R1, R2 etc.) and I am tempted to treat them and turn the pots back and forth a bit to make sure they're clean. Does anyone know if they are too position sensitive to set back into their original positions by eyeball? Any other comments about using or not using contact cleaner are also welcome. Thanks. PLEASE don't mess with ANY internal adjustments!!! Their operation may be interdependent and, once moved, may be a bitch to properly realign. Don't use contact cleaner on ANY internal components, or on any external plastic components. About its only use by a lay person should be on contacts on the slide-in connectors at the back of the unit. -- -Elliott Drucker |
#5
|
|||
|
|||
It's usually the case that 80% of the time there's a problem, it's
in the wiring/connectors. Another 10% times it's a cold/cracked solder joint. Unless it's something benign and independent like a sidetone adjustment or dimmer pot, for Pete's sake don't twiddle it! Having designed a whole slew of analog and digital circuits, I can assure you that there is usually an interdependency between them and they can usually be really twitchy. I screwed up the squelch adjustment on one of my radios and had to borrow an RF generator and obtain required pages from the adjustment manuals to fix it. Unless you've got the adjustment procedure manual, don't touch. Mike Noel wrote: : I forgot to mention the radio types. They are a mix of Bendix and : Bendix/King. The Nav1 failed to register glide slope information at one : airport, but seemed to work fine a few minutes later at another. Check for loose wiring. The Com1 : started receiving fine after rotating the frequency selector knobs a few : times, but still has terrible audio quality during transmit. Sidetone or actual transmission (from received radio)? Check overmodulation on mic if it's actually bad transmission. Not sure : wether it is the radio, the audio panel or something else. I wanted to take : my best shot at fixing these guys before resorting to an avionics shop. I'm : not entirely ingnorant in these matters since I was an avionics tech in the : army but have since moved on to other things. : -- : Regards, : Mike : : "Sven" wrote in message : news:Hd79b.443485$YN5.299972@sccrnsc01... : "Mike Noel" wrote in message : ... : I'm pulling out my older RF gear 1 by 1 to use a little Radio Shack : contact : cleaner on the interior switches. On my Nav radio I noticed a bank of : rotary resistors (guess they are resistors since they are labeled R1, R2 : etc.) and I am tempted to treat them and turn the pots back and forth a : bit : to make sure they're clean. Does anyone know if they are too position : sensitive to set back into their original positions by eyeball? Any : other : comments about using or not using contact cleaner are also welcome. : Thanks. : : If these are trim-pots that are mounted inside the radio and aren't : normally : adjusted during regular radio use, I'd recommend leaving them alone! They : shouldn't need cleaning if they aren't moved. The contact cleaner is for : cleaning the pots that you use such as the volume control. : : Are there problems with the radio??? If it ain't broke, keep your f'ing : mitts off! Leave it for your avionics tech... : : -- ************************************************** *********************** * The prime directive of Linux: * * - learn what you don't know, * * - teach what you do. * * (Just my 20 USm$) * ************************************************** *********************** |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
(sorta OT) Free Ham Radio Course | RST Engineering | Home Built | 51 | January 24th 05 08:05 PM |
1944 Aerial War Comes to Life in Radio Play | Otis Willie | Military Aviation | 0 | March 25th 04 10:57 PM |
Radio silence, Market Garden and death at Arnhem | ArtKramr | Military Aviation | 4 | February 12th 04 12:05 AM |
USAF = US Amphetamine Fools | RT | Military Aviation | 104 | September 25th 03 03:17 PM |
Ham Radio In The Airplane | Cy Galley | Owning | 23 | July 8th 03 03:30 AM |