|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 5th 08, 11:44 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Getting a little squeeze (riveting)
My new rivet squeezer arrived today from Aircraft Spruce and right on
time too. Anyway with a new tool to play with and nothing to rivet, I squeezed over a few pop rivets I had already installed. Holy crap Batman did those rivets look great and they're tighter than ever. I used 3/16" cupped dies on both sides and I have to say they're the best looking pop rivet joints I've ever seen. I can hardly wait to start setting solid rivets... Tony 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Riveting question | Michael Horowitz | Home Built | 4 | August 30th 08 01:58 PM |
| Question about rivets and riveting.... | gregg | Home Built | 6 | May 8th 05 04:05 AM |
| From the ground up ... question about riveting | Marco Rispoli | Home Built | 4 | July 19th 04 01:05 AM |
| Shinn brake linings - bonding vice riveting | Michael Horowitz | Owning | 0 | July 12th 04 04:47 PM |
| Dimpling and riveting pressures | Max Krippler | Home Built | 5 | November 11th 03 08:03 PM |
Threaded Mode