|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 2nd 03, 03:45 AM
|
|||
|
|||
inspection cover and ring?
I am looking for a source for aluminum inspection hole covers and backing rings for metal wings. I could make them, but would be nice to find some ready to install. TIA Mike 
|
|
#2
October 2nd 03, 05:23 AM
|
|||
|
|||
|
I am looking for a source for aluminum inspection hole covers and
backing rings for metal wings. I could make them, but would be nice to find some ready to install. TIA Mike http://www.midcont.com 1-800-325-0885, ask for Doug or Dennis. The covers are cheap, the rings might be a bit more.
|
|
#3
October 2nd 03, 07:54 PM
|
|||
|
|||
|
Univair is making 4 inch inspection rings and covers as part of their SB 31
Ercoupe center section inspection. I have installed two of the kits and they're complete even to the rivets. G A bit pricey , 8 for just under 200. However I couldn't make them for that price... Cheers: Paul I am looking for a source for aluminum inspection hole covers and backing rings for metal wings. I could make them, but would be nice to find some ready to install. TIA Mike
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
