|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 16th 04, 03:59 AM
|
|||
|
|||
Fading Rocker Switches
The Rocker switches in my Piper Arrow III are getting difficult to read.
The painted words on the switches have worn away. Is there anyway to rejuvenate these without buying all new rocker switches? -Sami 
|
|
#2
February 16th 04, 04:40 AM
|
|||
|
|||
|
On Sun, 15 Feb 2004 21:59:25 -0600, "O. Sami Saydjari"
wrote: The Rocker switches in my Piper Arrow III are getting difficult to read. The painted words on the switches have worn away. Is there anyway to rejuvenate these without buying all new rocker switches? Are the legends engraved? You could rub them with something that would fill the depressions. Or a paint that wouldn't melt the plastic that you could brush on and wipe off from the surface of the rockers. Athernatively, the depressions of the engravings could just be filled up with schmutz from your fingers. Cleaning would fix that. Don
|
|
#3
February 16th 04, 03:54 PM
|
|||
|
|||
|
Sami,
Sharpee. Michelle the pilot. O. Sami Saydjari wrote: The Rocker switches in my Piper Arrow III are getting difficult to read. The painted words on the switches have worn away. Is there anyway to rejuvenate these without buying all new rocker switches? -Sami -- Michelle P ATP-ASEL, CP-AMEL "Elisabeth" a Maule M-7-235B (no two are alike) Volunteer Pilot, Angel Flight Mid-Atlantic Volunteer Builder, Habitat for Humanity
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chrome plating rocker covers | Jim | General Aviation | 4 | May 14th 04 05:31 AM |
| FS on EBAY, circuit breaker switches | flyer | Home Built | 0 | December 3rd 03 06:59 PM |
Linear Mode
